NEW! Flipper!

Introvert ~ C206G


The Introvert is the world’s first flipper-opening back lock folding knife. More info...

byrd byrdRench ~ BY15P

click to enlarge

MSRP $109.95

Please Select:




Overall Length 7" (178mm) Blade Length 2.5" (64mm) Steel 8Cr13MoV
Closed Length 4.846" (119 mm) Edge Length 2.188" (56 mm) Weight 8 oz (228 g)
Blade Thickness .078" (2.25mm) Handle STAINLESS STEEL

byrd byrdWrench

As multitools go the byrdRench doesn't resemble any other pocket tool on the market. Unlike standard multitool fare it has a full-sized knife blade that opens/closes one handed and locks open like a real pocketknife. It also comes with a pocket clip and nylon sheath so if you're a hang-it-on-a-belt-loop person or a clip-in-my-pocket-person, you're covered.

The tool's housing is two stainless halves that join creating slip joint pliers (with a large or small bite) on one end and an adjustable 9/16" crescent wrench on the opposite end. Both work comfortably in the hand with contoured edges so there are no pinched fingers.

Separate the two halves and tucked inside is a set of four screwdriver bits including: A #2 and #3 Phillips-head as well as a #1 and #2 flat-head. The bit housing accepts any standard 1/4" sized bit including Allen and Torx-? wrenches to customize your tool arsenal. A rough file combination hole-starter slide into a spring set in the housing above the bits. A pivot holds the tool's two halves together. When rotated, the pieces extend and lock into a full-length easy to grip and torque magnetized screwdriver or crescent wrench. Releasing the pivot separates the screwdriver and knife portion of the tool from the crescent wrench. This allows you to use the crescent wrench and the screwdriver/knife independently and/or simultaneously. High performance 8Cr13MoV is the blade's steel and it comes in a plain cutting edge.

Pocket Carry - A nylon case is also included

Closing the knife one handed

Opening the slip joint pliers one handed

Rotating the two handles into the open & locked position

Removing the file/hole starter Removing the 1/4" bits Bits and file/hole starter Inserting the bits, they are held in place by a magnet. Using the screw driver Pressing the release to close it Aligning the pivot to take the handles apart Taking the handles apart Use each handle to tighten nuts and bolts from each side The knife can be used independently as well Closing the knife one handed
Related Items
byrd 8Tool Harp ~ BY13