szabofly pivots
- brandonreed2008
- Member
- Posts: 469
- Joined: Mon Jan 26, 2009 8:45 am
- Location: 408
szabofly pivots
ok so my friend came to me with a szabo asking me to tighten the pivot screws. So I went through my tools and found that T10 is too big, T9 is too small, metric hex does not fit, and standard hex does not fit. I looked through the forum and found someone did a review on it and put that the pivot screws were T10 but I have T10 bits new and old from different companies and they don't fit. Should I have him send it in or what (yes, he is in the military)
- CanisMajor
- Member
- Posts: 928
- Joined: Tue Jun 02, 2009 9:53 am
- Location: USA
Will the T10 not fit, as in is it too small/big for the screw? If its small try a T11, and if the T10 is too big try a T9. I have screws on a Delica IV that should be T6, but its too small so I use a T7. If that fails, I suggest having him send it in and maybe getting the screws replaced, if possible. Good luck.
Canis
Canis
Dare. Risk. Dream.
"Your body may be gone, I'm gonna carry you in.
In my head, in my heart, in my soul.
And maybe we'll get lucky and we'll both live again.
Well I don't know. I don't know. I don't know. Don't think so."
- Modest Mouse "Ocean Breathes Salty"
"Your body may be gone, I'm gonna carry you in.
In my head, in my heart, in my soul.
And maybe we'll get lucky and we'll both live again.
Well I don't know. I don't know. I don't know. Don't think so."
- Modest Mouse "Ocean Breathes Salty"