Spyderco Forums

Some years ago I found a Stainless Stretch with Kraton inserts. It has VG10 stee and actually came in a white box with Japanese paperwork.

Can anyone offer some information on this model? I like it, it’s unique, and the kraton definitely gives it an attractive two-tone finish with enhanced ergonomics.

Does the kraton hold up over time?

Thanks.

Hi American,

The "Stretch" history began back in 1983 with the "Hunter" model. The one shown above is one of the models in that historic lineage.

We gave up on the Kraton inserts on folders due to a variety of issues.

sal

Looks like an original C90 Stretch, nearly 20 years old.

I can’t comment on the durability of the Kraton, but I can comment that you seem to have a very nice example. Sounds like your knife is from the Japanese market.

That’s the original Stretch , I had a PE version but did not care for Kraton inserts . I knew that it was too good of a design to be dumped . I bought the CF version upon release . Still have it . MG2

I had a Boker Top Lock with Kraton inserts that was made in the 90's. After about 10 years, the inserts fell out. I tried a few different adhesives but never could get them to stay in again.

BornIn1500 wrote: ↑

Tue Jul 18, 2023 4:32 pm

I had a Boker Top Lock with Kraton inserts that was made in the 90's. After about 10 years, the inserts fell out. I tried a few different adhesives but never could get them to stay in again.

My vote would be to thoroughly clean both surfaces, and then applying 3M’s VHB tape. That’s what Chris Reeve does for their inlays.

[/quote]
My vote would be to thoroughly clean both surfaces, and then applying 3M’s VHB tape. That’s what Chris Reeve does for their inlays.
[/quote]

I've used 3M 847 adhesive to bond Teflon to smooth aluminum in the past.

Just wash the Kraton is soapy warm water, NOT hot, and rinse off and let dry for a day or so.

Then use VHB or even Kikisui tape ( available from sail and yacht suppliers )