Yup, found the right corbys for the job, the problem is making the stepped hole now ! I haven't found any countersink that has the good dimensions. Maybe drilling the pilot hole and then puting on a 6mm end mill bit and going at it that way. I'm just not that sure that nothing will move
Look what I got my hands on !
Re: Look what I got my hands on !
In the collection : Lots of different steels, in lots of different (and same) Spydercos.
Robin. Finally made an IG : ramo_knives
MNOSD member 004* aka Mr. N5s
Robin. Finally made an IG : ramo_knives
MNOSD member 004* aka Mr. N5s
- standy99
- Member
- Posts: 2223
- Joined: Sat Jul 22, 2017 11:07 am
- Location: Between Broome and Cairns somewhere
Re: Look what I got my hands on !
Ramonade wrote: ↑Wed Aug 30, 2023 10:14 amYup, found the right corbys for the job, the problem is making the stepped hole now ! I haven't found any countersink that has the good dimensions. Maybe drilling the pilot hole and then puting on a 6mm end mill bit and going at it that way. I'm just not that sure that nothing will move
It may help to go the opposite way 6mm and then drill the pilot holes
Im a vegetarian as technically cows are made of grass and water.
Re: Look what I got my hands on !
I've tried to do that before, and always had problems with the holes being misplaced. Maybe it won't be such a problem with my new drill press ! The old one I did all my work on had a big problem, in french we call that a "faux rond", it wiggled during drilling, making it almost impossible to be precise enough.standy99 wrote: ↑Thu Aug 31, 2023 8:09 amRamonade wrote: ↑Wed Aug 30, 2023 10:14 amYup, found the right corbys for the job, the problem is making the stepped hole now ! I haven't found any countersink that has the good dimensions. Maybe drilling the pilot hole and then puting on a 6mm end mill bit and going at it that way. I'm just not that sure that nothing will move
It may help to go the opposite way 6mm and then drill the pilot holes
In the collection : Lots of different steels, in lots of different (and same) Spydercos.
Robin. Finally made an IG : ramo_knives
MNOSD member 004* aka Mr. N5s
Robin. Finally made an IG : ramo_knives
MNOSD member 004* aka Mr. N5s