Sal,
I saw in another thread that you plan to increase the holes in the next Mule to 3/16". Could you confirm for me that they will be on the same center? I am just starting to make my handles and if I can just enlarge my current holes to 3/16 and have them line up with the next run that would be perfect. Thanks in advance for the response and for listening to your customers.
Sal, 3/16 inch mule hole question
- araneae
- Member
- Posts: 5495
- Joined: Wed Aug 09, 2006 10:10 pm
- Location: A lil more south of the Erie shore, Ohio
http://spyderco.com/forums/showthread.p ... 599&page=2
He did say they would be changed, but no mention of centering. I would hope that they would stay the same location if possible.
He did say they would be changed, but no mention of centering. I would hope that they would stay the same location if possible.
So many knives, so few pockets... :)
-Nick
Last in: N5 Magnacut
The "Spirit" of the design does not come through unless used. -Sal
-Nick
Last in: N5 Magnacut
The "Spirit" of the design does not come through unless used. -Sal