Cut up some strawberries with my newly reprofiled and sharpened Calypso Jr Super Blue.
Edge photo:
20181013_190701-1632x1224.jpg
I took it down to about 10 dps and touched it up a bit on the UF rods in the 30° slots.
Got some practicing to do but I'm really pleased with how it turned out.
Bet that cuts like the devil!
I waited just barely too long and couldn't get one.
Christ is risen from the dead, trampling down death by death, and on those in the tombs bestowing life!
I just started a job, this job conincidentally requires constant cutting miscellaneous objects and opening things for hours on in sometimes.
I carried my Tenacious, and PM2 S110V to work. My Tenacious was ok from about 7:30am to 11:30am. The Tenacious was utterly dulled. So, I used my S110V PM2 solely for all cutting without dulling, or any degradation.
I resharpened the ole 8CR13MOV on a dinner plate after I got home, the edge was razor sharp after only 2-3 minutes of light or no pressure!
Cut up some strawberries with my newly reprofiled and sharpened Calypso Jr Super Blue.
I took it down to about 10 dps and touched it up a bit on the UF rods in the 30° slots.
Got some practicing to do but I'm really pleased with how it turned out.
Bet that cuts like the devil!
I waited just barely too long and couldn't get one.
It sure does!
They're not all sold out yet are they? I saw the Calypso Jr thread popped up recently; they were in stock somewhere again. If they haven't all sold by now they might be easier to get hold of, since the mad rush seems to have abated somewhat.
- Connor
"What is a man profited, if he shall gain the whole world, and lose his own soul?"
Now there's a good reason to always have a knife on you.
One of the many reason beloved wife sometimes attacks me Connor. Though you’d think carrying a little knife would have to be easier than attaching a middle aged man rolling on the floor laughing. :rolleyes:
A day without laughter is a day wasted. ~ Charlie Chaplin
I used my s110v Military to cut some rope and now I can't find it. I really hope it's still on the dredge and I find it in the morning where I was cutting the rope today.
Cutting dry rot from a barn timber. The Manix LW in 110v. Dry rot is soft, but the blade goes through so effortlessly that it is easy to hit hardware or hard knots full force. Got the job done.
I just started a job, this job conincidentally requires constant cutting miscellaneous objects and opening things for hours on in sometimes.
I carried my Tenacious, and PM2 S110V to work. My Tenacious was ok from about 7:30am to 11:30am. The Tenacious was utterly dulled. So, I used my S110V PM2 solely for all cutting without dulling, or any degradation.
I resharpened the ole 8CR13MOV on a dinner plate after I got home, the edge was razor sharp after only 2-3 minutes of light or no pressure!
I’m not touching the S110V edge. No need!
Please explain this "dinner plate" sharpening technique.