Stuck pivot screw PM2
Stuck pivot screw PM2
I recently purchased a PM2 in M4 from knifeworks. From what I’ve read the PM 2 is a barrel pivot. I should be able to make adjustments to both sides of the pivot. However; the pivot screw that was under where the pocket clip was can not be adjusted. It won’t budge a mm. Should I not fiddle with it? Am I not supposed to be able to adjust it? Any help would be appreciated. Tried emailing Spyderco but no answer yet.
Re: Stuck pivot screw PM2
Probably best to put this question in GENERAL DISCUSSION.
It is in Spyderco Counterfeits, Clones, Replicas and not as many would visit.
It is in Spyderco Counterfeits, Clones, Replicas and not as many would visit.
3 x Endura 1 SE, 1 x Endura ? CE and a Black Pacific Salt. Want Aqua Salt, Fish Hunter and a Pacific Salt Yellow.
-
- Member
- Posts: 212
- Joined: Tue Jul 17, 2018 7:55 pm
- Location: Wisconsin, USA, Earth.
Re: Stuck pivot screw PM2
It does take a bit of torque to break them free. I usually just tighten the pocket clip side pivot all the way, then tighten the other side as needed to adjust the centering and action.