I'm looking to make some handles for my BRKT Bravo Necker II and want to have them removable. Does anyone know were to find quality hardware/spacer?
If decent hardware cannot be sourced, will epoxy alone be strong enough to hold the handle slabs on to the knife?
Depending on how this turns out I may do the same to my Izula, but both of these knives have open skeltonized handles that make me think that epoxying the handles would be a better option than hardware alone.
Sure the hardware and slabs can be sourced from BRKT, but I don't wanna fork out $50+ and have a cutout for the lanyard hole. I'd rather have solid handles with a hole to match the hole in the tang for a lanyard (if I even want that option).
The same goes for the Izula, the handle slabs for that don't cover the whole tang either. The handles for this one almost cost $20 and look like you might only be able to get two-three fingers around 'em.
Reply With Quote
Originally Posted by The Deacon
