Spyderco Forum Registered User
Tasman wave and polish
Waved my Tasman today...this is the first I've done in a few years, I used to cut into the hole, but I just went into the hump in front of the hole...also polished the spine and flats. The flats could use a bit more work, they're a bit cloudy, but I'm pretty happy with it. Man, H1 sure does polish up easy!
Spyderco Forum Registered User
Nice work!
Blake
Listing of Blade-Length Laws by State/County (Not My Website)
http://www.handgunlaw.us/documents/USKnife.pdf
Blerv's Semi-Comprehensive Flashlight Guide
Spyderco Forum Registered User
Care to fill us in a bit more on your steel polishing technique?
My
Native, Manix 2 (BD1, 154CM, S30V, M4, BD30P, XHP), Delica 4 (White, Red, Brown, Blue, BRG, G-10), Spyderhawk, D'fly G-10, Resiliance, Police 3, Volpe, Millie (S30V, XHP, D2), Superleaf, Forager, CPM-D2 Para, BRG Stretch, Caly 3.5-SB, Delica 3, Para-2 (XHP, 204P), SS Stretch, Rescue, Dyad Jr, Pingo, Caly Jr's, Caly 3 (CF, SB), Southard, AIR, Tasman, GB, Jess Horns, Rock Lobster
Mules> MT05,08,09,11,12,13,15,16
Pre-ordered >Cruwear Military
Gone for now>S90V-Manix
Spyderco Forum Registered User
Green rouge on a felt drum on a dremel. Easy-peasy. I need to try some better pics...it looks a lot nicer than mine show.
Spyderco Forum Registered User
Do you have any trouble getting an even finish due to the small felt wheels on the Dremel? Doesn't look like it in the pics but didn't know if you noticed it at earlier stages in the process.
Click here to zoom: Under the Microscope
Manix2, Elmax MT13, M4 Manix2, ZDP Caly3, ZDP Caly Jr, Centofante4, Super Blue Caly3.5, M390 Paramilitary2, Cruwear MT12, S90V Manix2, Techno, CF Dodo, XHP MT16, Ti-Mil Fluted Military, Super Blue Caly3, Calypso, Manix2 Lightweight , Yojimbo2, Salt I, Meerkat, 20CP Paramilitary2
Chris
Spyderco Forum Registered User
It was a bit tough, but not too bad. I had more trouble on VG10, the H1 didn't seem to have that issue.
Posting Permissions
Reply With Quote