Elmax and M390 ?

Discuss Spyderco's byrd knives.
JoeKansas
Member
Posts: 87
Joined: Fri Sep 24, 2004 10:33 am
Location: Topeka Kansas USA

Elmax and M390 ?

#1

Post by JoeKansas »

I saw that the sprint run of the squeak will have Elmax steel. I have no experience with Elmax or M390. From my EDC experience I personally rank : 1. ZDP189 2. S30V and tied for 3. VG10 and N690Co. Based on these rankings ,where would you place Elmax and M390 ? Thanks in advance for your help. Joe.
JoeKansas
Member
Posts: 87
Joined: Fri Sep 24, 2004 10:33 am
Location: Topeka Kansas USA

Re: Elmax and M390 ?

#2

Post by JoeKansas »

oops...wrong spot.
User avatar
paladin
Member
Posts: 1932
Joined: Sun Feb 27, 2011 5:51 pm
Location: Hotel Carlton-San Francisco

Re: Elmax and M390 ?

#3

Post by paladin »

JoeKansas wrote:oops...wrong spot.
Dang, I was really hoping for an announcement about an m390 Crow here... :p
TomAiello
Member
Posts: 6655
Joined: Tue Jun 11, 2013 10:34 pm
Location: Twin Falls, ID

Re: Elmax and M390 ?

#4

Post by TomAiello »

I like Elmax slightly better than s30v. I like M390 quite a lot better than either of them.

Elmax sharpens up "better" (meaning a more screamingly sharp edge) than s30v for me, and holds it's working edge about the same. I also find it easier to touch up than s30v.

I actually like ZDP better than anything else for "surgically sharp" small knives (the Dragonfly in ZDP is fantastic for this), but I find I have trouble keeping them "working sharp" for general purpose use, and re-sharpening them when they dull is harder for me.

For a small precise knife, my favorite of the steels you listed is ZDP. For a general purpose knife, my favorite is m390.
User avatar
sal
Member
Posts: 16964
Joined: Fri Sep 24, 2004 12:00 pm
Location: Golden, Colorado USA

Re: Elmax and M390 ?

#5

Post by sal »

Hi Mithandabag,

Welcome to our forum.

I would suggest that you post these thoughts on the Spyderco general forum. This sub forum is for the byrd brand.

al
Post Reply